Shopping Cart
Spray and Forget 24 oz. Outdoor Furniture Cleaner

Spray and Forget 24 oz. Outdoor Furniture Cleaner

  • $28.99

BARE FIBERGLASS In Good Condition Begin by scrubbing well using soap and water and a stiff brush. Rinse with fresh water and allow to dry. Wipe a small area with a clean rag that has been wetted with Fiberglass Solvent Wash 202. While the surface is still wet, wipe with a clean, dry rag. Continue this process until the entire surface has been cleaned. Sand using 180- 220 grade (grit) paper. Remove sanding residue.

MOLDED IN NON-SKID SURFACES Scrub with Fiberglass Surface Prep YMA601 or Solvent Wash 202V using a 3M Doodlebug™ and a maroon Scotch-Brite ® pad. Rinse with fresh water.

PREVIOUSLY PAINTED SURFACES In Good Condition The surface must be clean and dry. Sand with 220-320 grade (grit) paper. Remove sanding residue. In Poor Condition Remove all previous coatings and prime the substrate.

BARE WOOD Sand surface, wipe clean. Apply Prekote Primer. Sand surface, wipe clean. METAL Use Interprotect 2000E to prime the surface of the prepared metal. See the Interprotect 2000E Technical Datasheet for bare metal preparation guidelines.

CLEAR EPOXY Clean as for Bare Fiberglass above. Sand with 80 grade (grit) paper. Remove sanding residue. Apply one coat of Epoxy Barrier-Kote 404/414. Method Sand the primer with 180-220 grade wet or dry paper. Remove dust with a dust wipe.

Apply 1-2 coats.

Hints Mixing Stir well before use.

Thinner Brushing Liquid 333

Cleaner Special Thinner 216. Ventilation and Humidity Control Apply in dry, well ventilated conditions.  

Other

For best results either stipple by brush or use a mohair roller.

Some Important Points Product temperature should be minimum 10°C/50°F and maximum 35°C/95°F. Ambient temperature should be minimum 5° C/41°F and maximum 35°C/95°F. Substrate temperature should be minimum 5°C/41°F and maximum 35°C/95°F. Compatibility/Substrates Suitable for all substrates and filled surfaces. Not suitable for permanently immersed surfaces. Do not clean with highly alkaline cleaners. Number of Coats 1-2 Coverage (Theoretical) - 386.7 ft²/gal Recommended DFT 2 mils dry Recommended WFT 3.7 mils wet Application Methods Brush, Roller 


Spray and Forget is a unique, outdoor furniture cleaner that works to remove dirt, grime, bird droppings and leaf tannins. It also removes green and black biological stains caused by algae, mold, and mildew. Spray and Forget shines and rejuvenates hard surfaces as well as provides UV protection and a protective barrier to prevent stains caused by biological growths from returning. Works great on patio furniture, furniture covers, BBQ grill covers, awnings, hammocks, flags, pool coverings and many other outdoor surfaces.

  • Rejuvenates, prevents, time release, color fade protection, and planet friendly
  • Provides UV protection
  • No rinse formula on fabric for algae, mold and mildew stains
  • Cleans, shines and protects
  • Works on: awnings, furniture coverings, BBQ grill covers, hammocks, flags, swings, pool coverings and tarps
  • Spray and wipe formula for hard surfaces
  • Provides a protective barrier to prevent future stains caused by algae, mold and mildew

Write a review

Note: HTML is not translated!
    Bad           Good