Shopping Cart

Shipping Estimate

Applies to this product only
Country:
Region / State:
Post Code:
INTERLUX Epoxy Primekote White

INTERLUX Epoxy Primekote White

  • $60.99

BARE FIBERGLASS In Good Condition Begin by scrubbing well using soap and water and a stiff brush. Rinse with fresh water and allow to dry. Wipe a small area with a clean rag that has been wetted with Fiberglass Solvent Wash 202. While the surface is still wet, wipe with a clean, dry rag. Continue this process until the entire surface has been cleaned. Sand using 180- 220 grade (grit) paper. Remove sanding residue.

MOLDED IN NON-SKID SURFACES Scrub with Fiberglass Surface Prep YMA601 or Solvent Wash 202V using a 3M Doodlebug™ and a maroon Scotch-Brite ® pad. Rinse with fresh water.

PREVIOUSLY PAINTED SURFACES In Good Condition The surface must be clean and dry. Sand with 220-320 grade (grit) paper. Remove sanding residue. In Poor Condition Remove all previous coatings and prime the substrate.

BARE WOOD Sand surface, wipe clean. Apply Prekote Primer. Sand surface, wipe clean. METAL Use Interprotect 2000E to prime the surface of the prepared metal. See the Interprotect 2000E Technical Datasheet for bare metal preparation guidelines.

CLEAR EPOXY Clean as for Bare Fiberglass above. Sand with 80 grade (grit) paper. Remove sanding residue. Apply one coat of Epoxy Barrier-Kote 404/414. Method Sand the primer with 180-220 grade wet or dry paper. Remove dust with a dust wipe.

Apply 1-2 coats.

Hints Mixing Stir well before use.

Thinner Brushing Liquid 333

Cleaner Special Thinner 216. Ventilation and Humidity Control Apply in dry, well ventilated conditions.  

Other

For best results either stipple by brush or use a mohair roller.

Some Important Points Product temperature should be minimum 10°C/50°F and maximum 35°C/95°F. Ambient temperature should be minimum 5° C/41°F and maximum 35°C/95°F. Substrate temperature should be minimum 5°C/41°F and maximum 35°C/95°F. Compatibility/Substrates Suitable for all substrates and filled surfaces. Not suitable for permanently immersed surfaces. Do not clean with highly alkaline cleaners. Number of Coats 1-2 Coverage (Theoretical) - 386.7 ft²/gal Recommended DFT 2 mils dry Recommended WFT 3.7 mils wet Application Methods Brush, Roller 


Epoxy Primekote®  is a multi-purpose two-part epoxy primer that is the recommended primer for use with two-part finishes such as Perfection® Polyurethane and can also be overcoated with any Interlux topside paint. It is also used as part of a system to resurface cracked and crazed gelcoat prior to the application of topside paint and over clear epoxies to eliminate the effects of amine blush. It’s bright white color makes it ideal for priming bilge and locker areas.

Suitable under all Interlux topside finishes

Can be used to re-surface cracked and crazed gelcoat prior to the application of topside paint

Can be used over clear epoxies as a sanding surfacer and to eliminate the effects of amine blush

Application by spray or roller/ brush

Write a review

Note: HTML is not translated!
    Bad           Good